
King Kahuka's Throne
미니피규어 (4)

Islander - Male
fig-005502×2

Pirate - Blue Jacket, Light Gray Legs, Brown Tricorne (3626b Head)
fig-000662×1

Islander - King Kahuka, Mask
fig-001092×1

Pirate - Red/Black Stripes, Black Legs, Blue Bandana
fig-005126×1
부품 목록 (78)

Cone 1 x 1 [No Top Groove]
×6
Plate 1 x 1
×5
Brick 1 x 2
×4
Slope 45° 2 x 1 with Bottom Pin
×4
Brick Round 1 x 1 Open Stud
×4
Plate 1 x 3
×4
Weapon Pike / Spear Round End
×4
Plate Round 1 x 1 with Solid Stud
×4
Plate Special 1 x 2 with 1 Stud without Groove (Jumper)
×3
Plate Special 1 x 1 with Clip Vertical [Thick U Clip]
×3
Brick Curved 1 x 2 x 1 1/3 with Curved Top
×3
Brick 2 x 2 Corner
×2
Plant, Palm Leaf Large 10 x 5
×2
Equipment Oar / Paddle
×2
Weapon Gun / Pistol Flintlock
×2
Shield Ovoid with Indigo Islanders Print
×2
Plate 2 x 4
×2
Plate 1 x 2
×2
Plate 1 x 2
×2
Slope 45° 2 x 1 with Bottom Pin
×2
Tile 2 x 2 with Groove
×2
Plate Special 1 x 2 with 1 Stud without Groove (Jumper)
×2
Plate Special 1 x 2 with Handles [Flat Ends / Low Attachment]
×2
Antenna 1 x 4 with Rounded Top
×2
Plate Round 2 x 2 with Axle Hole Type 1 (+ Opening)
×2
Brick Special 1 x 1 with Headlight
×2
Slope 33° 3 x 1
×2
Slope Inverted 34° 3 x 1 without Internal Stopper
×2
Plate Special 1 x 4 Offset with Bar Holes
×2
Panel 1 x 2 x 1 [Square Corners]
×2
Plate Special 1 x 1 with Clip Horizontal [Thick U Clip]
×2
Plate Special 1 x 1 with Clip Horizontal [Thick U Clip]
×2
Plate Round 1 x 1 with Solid Stud
×2
Plate Round 1 x 1 with Solid Stud
×2
Plant, Palm Leaf Small
×2
Animal Body Part, Horn, Cattle
×2
Flag 2 x 2 Square [Thin Clips] with Skull and Crossbones Print
×1
Plate 2 x 2 Corner
×1
Weapon Sword / Cutlass
×1
Boat / Rowing Boat 14 x 5 x 2 with Oarlocks [2 Hollow Inside Studs]
×1
Tile Special 1 x 1 with Clip and Straight Tips
×1
Brick 1 x 4 with Bottom Tubes, Lowered Center Cross Support
×1
Plate 2 x 2
×1
Plate 2 x 2
×1
Slope 45° 2 x 2
×1
Tile 2 x 2 with Blue and Yellow Map Print
×1
Tile 1 x 2 with Groove
×1
Turntable 2 x 2 Plate - Top
×1
Turntable 2 x 2 Plate, Base
×1
Plate 1 x 4
×1
Plate Special 1 x 2 with 1 Stud without Groove (Jumper)
×1
Plate Special 1 x 2 with 1 Stud without Groove (Jumper)
×1
Plate 2 x 6
×1
Plate 2 x 6
×1
Baseplate 16 x 16
×1
Brick Round 2 x 2 with Axle Hole
×1
Plate Round 2 x 2 with Axle Hole Type 1 (+ Opening)
×1
Tile Round 2 x 2 with Zebra Stripes Print
×1
Boat, Mast 2 x 2 x 9 2/3 Bar with Slot on Top and 2 Finger Hinge on Two Sides
×1
Hinge Bar 8L with 3 Fingers and Open End Stud
×1
Treasure Chest Bottom without Rear Slots
×1
Treasure Chest Lid [Thick Hinge]
×1
Money / Coin with "10" Sans-serif Type
×1
Money / Coin with "20" Sans-serif Type
×1
Money / Coin with "30" Sans-serif Type
×1
Money / Coin with "40" Sans-serif Type
×1
Animal Body Part, Alligator / Crocodile Body
×1
Animal Body Part, Alligator / Crocodile / Dragon Upper Jaw / Dinosaur Tongue
×1
Animal Body Part, Alligator / Crocodile / Dragon / Dinosaur Tail
×1
Rock Panel Rectangular 4 x 10 x 6 (aka BURP)
×1
Wave / Flame Rounded with Base Pegs
×1
Plate Round 1 x 1 with Solid Stud
×1
Sail, 9 x 11, with 3 Holes and Black Stripes Print
×1
Headwear Accessory Plume / Feather Headdress
×1
Weapon Sword / Cutlass
×1
Plate Round 1 x 1 with Solid Stud
×1
Plate Round 1 x 1 with Solid Stud
×1
Plate Round 1 x 1 with Solid Stud
×1