
Mars Spacecraft Exploration Missions
미니피규어 (1)
부품 목록 (155)

Plate 1 x 2
×12
Plate 1 x 6
×7
Wedge Sloped 45° 2 x 2 Corner
×6
Tile Special 1 x 2 with Sloped Walls AKA Money / Gold Bar [Ingot]
×6
Brick Special 1 x 2 with 2 Studs on 1 Side
×4
Bracket 5 x 2 x 1 1/3 with Holes, Pin Bottom
×4
Slope Curved 2 x 1 No Studs [1/2 Bow]
×4
Plate Special 1 x 2 with 5.9mm Towball Socket and Towball
×4
Plate Special 1 x 2 5.9mm Centre Side Towball Socket
×4
Slope 45° 2 x 1 with 2/3 Cutout [New Version]
×4
Wheel Skateboard / Trolley
×4
Wheel Holder, Plate, Round 2 x 2 Thin with Clips
×4
Bracket 1 x 2 - 1 x 4 [Rounded Corners at Bottom, Square Corners at Top]
×4
Plate 1 x 8
×4
Plate Round 2 x 2 with Axle Hole Type 1 (+ Opening)
×4
Plate Special 1 x 4 with 2 Studs with Groove [New Underside]
×4
Plate Special 1 x 2 [Open O Top Clip]
×4
Dish 2 x 2 Inverted [Radar]
×4
Plate Special 1 x 2 [Side Handle Closed Ends]
×4
Slope Curved 3 x 1 No Studs
×4
Cone 1 x 1 [Top Groove]
×4
Brick Curved 1 x 2 x 1 1/3 with Curved Top
×4
Wave / Flame Rounded with Base Rim
×4
Wave / Flame Rounded with Base Rim
×4
Plate Special 1 x 2 with Clip Horizontal on End
×4
Tile Round 1 x 1
×4
Support Round 2 x 2 x 2 Stand with Reinforced Underside
×3
Plate 1 x 4
×3
Bracket 2 x 2 with 1 x 2 Vertical Studs
×3
Slope Inverted 45° 4 x 2 Double with 2 x 2 Recessed
×3
Slope 30° 1 x 1 x 2/3 (Cheese Slope)
×3
Slope Curved 4 x 1 No Studs [Stud Holder with Symmetric Ridges]
×2
Slope Curved 4 x 1 Inverted
×2
Tile Round 1 x 1 with Hollow Bar
×2
Tile Special 2 x 3 Pentagonal
×2
Tile Special 2 x 3 Pentagonal
×2
Plate Special 1 x 2 with End Towball
×2
Wing, Tail 4 x 1 x 3
×2
Tile Special 1 x 2 Grille with Bottom Groove
×2
Wedge Plate 3 x 6 Cut Corners
×2
Tile Special 1 x 2 with Handle
×2
Wedge Plate 2 x 2 Cut Corner
×2
Lever Small Base with Black Lever
×2
Brick 1 x 4
×2
Plate 2 x 4
×2
Bar 1 x 8 with Brick 1 x 2 Curved Top End (Axle Holder Inside Small End)
×2
Slope 45° 2 x 1 with Bottom Pin
×2
Slope 45° 2 x 1 with Bottom Pin
×2
Slope 45° 2 x 1 with Bottom Pin
×2
Slope Curved 2 x 2 with Lip, No Studs
×2
Brick Round 1 x 1 Open Stud
×2
Plate Special 1 x 2 with Handles [Flat Ends / Low Attachment]
×2
Hinge Brick 1 x 2 Base
×2
Hinge Brick 1 x 2 Top Plate Thin
×2
Antenna 1 x 4 with Flat Top
×2
Engine, Strakes, 2 x 2 Thin Top Plate
×2
Dish 3 x 3 Inverted [Radar]
×2
Tail Shuttle - Small
×2
Plate Special 1 x 4 Offset with Bar Holes
×2
Brick Special 1 x 2 x 2/3 with Studs on Sides
×2
Geode / Rock with Trans-Light Blue Crystal Pattern
×2
Grab Claw with Axle
×2
Engine / Air Scoop 2 x 2
×2
Hinge Tile 1 x 3 Locking with 1 Finger on Top with Cutout
×2
Slope 30° 1 x 1 x 2/3 (Cheese Slope)
×2
Wedge Plate 6 x 3 Right
×2
Wedge Plate 6 x 3 Left
×2
Slope Inverted 45° 6 x 4 Double with 4 x 4 Recessed and 3 Holes
×2
Slope 65° 2 x 1 x 2
×2
Wedge Plate 6 x 6 Cut Corner
×2
Plate Special 1 x 4 with Angled Tubes
×2
Plate Round 1 x 1 with Solid Stud
×2
Cone 3 x 3 x 2
×2
Equipment Telescope / Torch / Spyglass, Support Round 1 x 1 x 1 2/3
×2
Tile Special 2 x 3 with 2 Clips without Tab between Clips with Solar Panel print
×2
Tile 2 x 6
×2
Wave / Flame Rounded Large with Marbled Trans-Yellow Pattern
×2
Windscreen 7 x 4 x 2 Round with Handle
×2
Brick Round 2 x 2 Truncated Cone
×2
Engine, Smooth Small, 1 x 2 Side Plate with Axle Holders and Slot
×2
Bar Holder with Clip
×1
Slope Curved 2 x 1 No Studs [1/2 Bow]
×1
Tile Special 1 x 1 with Clip with Rounded Edges
×1
Plate Special Round 2 x 2 with Center Stud (Jumper Plate)
×1
Hair Mid-Length Swept Sideways
×1
Equipment Net
×1
Plate 2 x 12
×1
Technic Axle Towball
×1
Wedge Sloped Inverted 6 x 6 x 1 Triple
×1
Brick 2 x 4
×1
Plate 2 x 2
×1
Tool Jackhammer / Motor Hammer
×1
Plate 1 x 2
×1
Brick Round 2 x 2 Dome Top, Hollow Stud
×1
Slope 45° 2 x 2 with Computer Screen, with Crosshairs print
×1
Slope 45° 2 x 2 with Computer Screen, Lever Print
×1
Brick 1 x 2 without Bottom Tube
×1
Plate Round 1 x 1 with Hollow Stud and Horizontal Bar 1L
×1
Plant, Banana
×1
Minifig Head, Thin Eyebrows, Eyelashes, White Pupils and Peach Lips Smile Print
×1