
Sailboat Rescue
미니피규어 (2)

Coast Guard, Open Sand Blue Jacket with Badge over Orange Sweater, Blue Cap, Yellow Life Vest, Silver Sunglasses
fig-007264×1

Man, Hoodie over Green and Lime Shirt, Life Vest, Black Hair
fig-007265×1
부품 목록 (112)

Slope 45° 2 x 1 with Bottom Pin
×8
Tile Special 1 x 1 with Clip with Rounded Edges
×6
Slope 45° 2 x 2
×6
Slope 30° 1 x 1 x 2/3 (Cheese Slope)
×6
Tile Special 1 x 2 Grille with Bottom Groove
×5
Slope 30° 1 x 1 x 2/3 (Cheese Slope)
×5
Plate Round 2 x 2 with Rounded Bottom [Boat Stud]
×4
Brick 1 x 6
×4
Plant, Round 1 x 1 - 3 Bamboo Leaves
×4
Plate 1 x 2
×4
Brick 2 x 3
×3
Brick 1 x 2
×3
Plate 1 x 2
×3
Plate 1 x 6
×3
Slope 65° 2 x 2 x 2 with Bottom Tube
×3
Hose Rigid 3mm D. 14L / 11.2cm
×3
Plate Round 1 x 1 with Open Stud
×3
Tile Special 2 x 2 Inverted
×2
Plate Special 1 x 2 with Clip Horizontal on Side
×2
Slope Curved 2 x 1 No Studs [1/2 Bow]
×2
Brick 1 x 1 x 3
×2
Plate Special 1 x 2 with 1 Stud with Groove and Inside Stud Holder (Jumper)
×2
Tile Special 1 x 1 with Clip with Rounded Edges
×2
Brick Arch 1 x 3 x 2 Inverted [Inside Bow]
×2
Wing, Tail 4 x 1 x 3
×2
Tile 1 x 4 with Groove
×2
Equipment Binoculars
×2
Plate 2 x 3
×2
Plate 2 x 2
×2
Plate 1 x 2
×2
Slope 45° 2 x 4
×2
Slope 45° 2 x 2 Double Concave
×2
Plate Special 2 x 8 with Door Rail
×2
Tile 1 x 1 with Groove
×2
Brick 1 x 2 x 2 with Inside Stud Holder
×2
Slope Inverted 45° 2 x 2 [Ovoid Bottom Pin, Bar-sized Stud Holes]
×2
Slope Inverted 45° 2 x 2 [Ovoid Bottom Pin, Bar-sized Stud Holes]
×2
Slope Curved 2 x 2 No Studs - 3 Recessed Side Ports
×2
Tap 1 x 1 without Hole in Spout
×2
Wedge Curved 1 x 2 x 2/3 No Studs, Wing End
×2
Plate Special 1 x 2 [Side Handle Closed Ends]
×2
Slope Curved 4 x 6 x 2/3 Triple Curved with 4 Studs
×2
Propeller 3 Blade 3 Diameter with Axle Cross
×2
Plate Special 1 x 2 with Clips Horizontal [Open O Clips]
×2
Windscreen 5 x 2 x 1 2/3
×2
Plate Round 1 x 1 with Solid Stud
×2
Brick Special 2 x 2 with Pin and Axle Hole
×2
Plate Special 2 x 2 with Groove and Center Stud (Jumper)
×2
Plate Special 2 x 2 x 2/3 with Two Studs On Side and Two Raised [Solid Anti-stud]
×2
Animal Body Part, Shark Body with Three Gill Slits
×1
Slope Curved 2 x 2 x 2/3
×1
Plate Special 1 x 2 with 1 Stud with Groove and Inside Stud Holder (Jumper)
×1
Technic Axle Pin 3L with Friction Ridges Lengthwise and 2L Axle
×1
Equipment Radio [Extended Handle, Expanded Speaker Grille]
×1
Animal Body Part, Shark Head with Rounded Nose with Black Eyes Print
×1
Technic Pin Connector Hub with 1 Axle
×1
Large Figure Weapon Lightsaber Hilt with Axle Hole and Two Bar Holders
×1
Brick 2 x 6
×1
Plate Round 2 x 2 with Rounded Bottom [Boat Stud]
×1
Windscreen 6 x 6 x 2
×1
Sail, Triangular, 10 x 19 with Green and Lime Chevrons Print
×1
Brick 1 x 1
×1
Plate 2 x 4
×1
Plate 6 x 16
×1
Brick Round 2 x 2 Dome Top, Hollow Stud
×1
Bar 4L (Lightsaber Blade / Wand)
×1
Hinge Cylinder 1 x 2 Locking with 2 Click Fingers and Axle Hole, 9 Teeth
×1
Technic Axle and Pin Connector Angled #1
×1
Technic Brick 1 x 2 with Axle Hole Type 1 [+ Opening] and Bottom Pin
×1
Brick 1 x 2 x 2 with Inside Stud Holder
×1
Slope 33° 3 x 4
×1
Slope 33° 3 x 2
×1
Slope 33° 3 x 2
×1
Sticker Sheet for Set 60168-1
×1
Plate 1 x 8
×1
Plate 1 x 4
×1
Plate 2 x 6
×1
Steering Stand 1 x 2 with Black Steering Wheel
×1
Weapon Lance
×1
Equipment Cup / Mug [Plain]
×1
Hinge Cylinder 1 x 3 Locking with 1 Finger and Technic Friction Pin with Round Hole
×1
Tile 1 x 8 with Groove
×1
Equipment Weapon, Loudhailer / Speaker / Blaster / Space Gun
×1
Flag 2 x 2 Trapezoid with Flat Area between Clips
×1
Bracket 1 x 2 - 2 x 2
×1
Bar 1L with Clip [Cut Edges and One Side Hole] [Gap in Clip]
×1
Plate Round 1 x 1 with Solid Stud
×1
Plate Round 1 x 1 with Solid Stud
×1
Boat / Rubber Raft / Dinghy, Large 22 x 10 x 3
×1
Tile 1 x 6 with Groove
×1
Plate Round 1 x 1 with Open Stud
×1
Slope 30° 1 x 2 x 2/3
×1
Weapon Gun / Torch (Space) [No Grooves]
×1
Bar 5L with Handle (Friction Ram)
×1
Boat Hull 8 x 28 x 3
×1
Boat Deck 8 x 28 x 3
×1
Tile Round 1 x 1
×1
Tile Round 1 x 1
×1
Bar 4L (Lightsaber Blade / Wand)
×1
Tile 1 x 1 with Groove
×1