
Hornet Scout
미니피규어 (2)
부품 목록 (40)

Support Leg Small [Insectoids]
×4
Arm Holder Brick 1 x 2 with 2 Horizontal Fingers
×3
Brick 1 x 2
×3
Slope 45° 2 x 2
×3
Cone 1 x 1 [No Top Groove]
×3
Tile Special 1 x 2 Grille with Bottom Groove
×2
Plate 2 x 12
×2
Antenna 8H Whip
×2
Plate 2 x 4
×2
Plate 2 x 2
×2
Slope 45° 2 x 1 with Bottom Pin
×2
Engine - Smooth, Small 1 x 2 Side Plate [With Axle Holders]
×2
Plate 1 x 3
×2
Plate Special 1 x 1 with Clip Light, Bar Hole [Thick Ring]
×2
Arm Piece 90° Turn [2 / 3 Fingers]
×2
Arm Grab Jaw
×2
Plate Special 1 x 4 Offset with Bar Holes
×2
Plate Special 1 x 1 with Clip Horizontal [Thick U Clip]
×2
Plate Round 1 x 1 with Solid Stud
×2
Wedge Plate 3 x 6 Cut Corners
×1
Brick 2 x 2
×1
Equipment Space Scanner
×1
Plate 2 x 3
×1
Rock 2 x 2 Crystal 3 Point
×1
Plate 1 x 2
×1
Wing Insectoid Small with Arm Hinge and Circuitry Print Right (Print on Top, Tip at Right, Logo at Back Edge)
×1
Wing Insectoid Small with Arm Hinge and Circuitry Print Left (Print on Top, Tip at Left, Logo at Back Edge)
×1
Tile 2 x 2 with Insectoid Logo in Triangle Print
×1
Tile 1 x 2 with Mars Orbit Display Print
×1
Slope 33° 3 x 2 with Insectoid Scope Print
×1
Plate 1 x 6
×1
Technic Brick 1 x 2 [1 Pin Hole]
×1
Slope Inverted 33° 3 x 2, No Connections between Studs, Ovoid Bottom Pin
×1
Plate Special 1 x 2 with 1 Stud without Groove (Jumper)
×1
Arm Grab Jaw Holder, 3 Fingers
×1
Panel 1 x 2 x 1 [Square Corners]
×1
Wedge Plate 8 x 8 with 3 x 4 Cutout
×1
Brick Special 2 x 2 with Pin and Axle Hole
×1
Sticker Sheet for Sets 2964-1, 2965-1, 5316-1, 6817-1, 6837-1, 6903-1, 6905-1, 6907-1, 6909-1, 6919-1, 6969-1, 6977-1
×1
Plate Round 1 x 1 with Solid Stud
×1
