
Slave I
부품 목록 (43)

Slope 45° 2 x 1 with Bottom Pin
×6
Slope 30° 1 x 1 x 2/3 (Cheese Slope)
×6
Plate Round 1 x 1 with Solid Stud
×5
Tile 1 x 2 with Groove
×4
Brick Curved 1 x 2 x 1 1/3 with Curved Top
×4
Plate 2 x 4
×3
Technic Brick 1 x 2 [1 Pin Hole]
×3
Tile Special 1 x 2 Grille with Bottom Groove
×2
Equipment Binoculars
×2
Brick Curved 2 x 2, Two Top Studs
×2
Plate Round Corner 3 x 3
×2
Plate Round Corner 3 x 3
×2
Hinge Plate 1 x 2 Locking with 1 Finger On Top
×2
Hinge Cylinder 1 x 2 Locking with 2 Click Fingers and Axle Hole, 9 Teeth
×2
Slope Curved 2 x 2 with Lip, No Studs
×2
Technic Bush 1/2 Smooth with Axle Hole Semi-Reduced
×2
Plate 1 x 6
×2
Technic Bush
×2
Bar 1L with Clip [Cut Edges and One Side Hole] [Gap in Clip]
×2
Slope Curved 3 x 1 No Studs
×2
Slope 30° 1 x 1 x 2/3 (Cheese Slope)
×2
Brick Special 1 x 1 with Stud on 1 Side
×2
Wedge Plate 3 x 6 Cut Corners
×1
Tile 1 x 4 with Groove
×1
Brick 2 x 3
×1
Brick 2 x 2
×1
Plate 2 x 2
×1
Plate 1 x 2
×1
Slope Inverted 45° 2 x 2 [Ovoid Bottom Pin, Bar-sized Stud Holes]
×1
Plate 2 x 6
×1
Plate Round 2 x 2 with Axle Hole Type 1 (+ Opening)
×1
Wedge Sloped 4 x 2 Triple Left
×1
Wedge Sloped 4 x 2 Triple Right
×1
Technic Axle 7
×1
Plate Special 2 x 2 with Wheel Holders
×1
Brick Curved 2 x 4 Double, No Studs, without Groove
×1
Slope 30° 1 x 2 x 2/3
×1
Technic Bush 1/2 Smooth with Axle Hole Semi-Reduced
×1
Technic Bush
×1
Bar 1L with Clip [Cut Edges and One Side Hole] [Gap in Clip]
×1
Slope 30° 1 x 1 x 2/3 (Cheese Slope)
×1
Slope 30° 1 x 1 x 2/3 (Cheese Slope)
×1
Plate Round 1 x 1 with Solid Stud
×1